Wellborn Bathroom Remodeling Nationwide

Wellborn Bathroom Remodeling: The West Palm Beach Owner’s Guide

Wellborn bathroom remodeling in West Palm Beach typically runs $9,000-$28,000 for a full replacement, with partial updates like vanity or shower conversions starting lower. We stock Wellborn-compatible cabinet hardware, drawer glide systems, and hinge sets for same-day repair on most series, and we carry KraftMaid and Silestone lines for full refits. Most West Palm Beach homeowners realize something’s wrong when a vanity drawer starts sagging or a cabinet door won’t stay aligned after a humid summer, signs that the particleboard core has swollen or the soft-close mechanism has seized.

Call (561) 475-3903

Which Wellborn Models This Applies To

Wellborn’s three residential lines, Select, Premier, and Estate, each use different hinge bore patterns and drawer box depths. The Select series runs a 35mm cup hinge with standard 1/2-inch overlay; Premier and Estate move to a 1-1/4-inch full-overlay hinge with integrated soft-close dampers. Drawer glides differ too: Select uses a 3/4-extension epoxy-coated slide rated for 75 pounds, while Estate upgrades to a full-extension, 100-pound undermount with locking disconnect tabs. The model number is stamped on the hinge cup or printed on a foil label inside the door stile, usually starting with “WB” followed by a four-digit year code.

We source OEM Wellborn hardware through their Alabama distribution network, though for discontinued series we spec Blum and Salice aftermarket equivalents that match the bore pattern and load rating. The aftermarket route saves roughly 15-20% on parts, but we flag when the original spec used a thicker door panel or heavier hinge plate that the replacement can’t support. For West Palm Beach jobs along Flagler Drive, we’ve learned to verify the series year before ordering; Wellborn shifted hinge suppliers in 2019, and the hole spacing changed by 3 millimeters. That’s enough to throw off a template if you’re working fast.

Signs Your Wellborn Bathroom Remodeling Is Failing

• Doors hang crooked or won’t latch. The hinge cup has wallowed out in the particleboard stile, usually from repeated slamming in high-humidity conditions. The door weight then shifts onto the remaining screws, which strip out in sequence until the whole assembly loosens.
• Drawers stick, jerk, or fall off the track. Epoxy-coated slides collect salt and mineral residue from West Palm Beach’s hard water and coastal air. The coating flakes, the ball bearings corrode, and the drawer box starts dropping at full extension.
• Soft-close feature stops working or slams shut. The hydraulic damper cartridge inside the hinge or slide has leaked its silicone fluid, a failure that accelerates past the five-year mark in Florida’s heat and humidity cycles.
• Visible swelling or delamination at door edges. Moisture has breached the thermofoil or paint film, typically near the sink splash zone or where a vent fan is undersized. The MDF core expands, the finish bubbles, and the door profile distorts enough to rub the frame.
• Cabinet box itself feels spongy or smells musty. Water has reached the cabinet floor or side panel, often from a slow leak at the p-trap or supply valve. The particleboard substrate degrades to oatmeal consistency, and the whole unit loses structural integrity.

Before

After

Replacement Cost & What’s Included

A full Wellborn bathroom remodel in West Palm Beach runs $9,000-$28,000, with small bathroom updates at $5,000-$12,000. Partial work breaks out as follows:

What drives the range: material grade (Select vs. Estate), whether we’re moving plumbing rough-in, and the condition of the wall substrate behind the old cabinets. We quote a flat written price before any work starts, per Clause 1 of The Haven Standard. The number includes parts, labor, haul-away, and a documented photo record of the demolition and install. Our 365-Day Done Right Promise covers the workmanship; Wellborn’s own warranty covers manufacturer defects on cabinets.

DIY or Call Us?

A homeowner with a screwdriver and patience can swap a single hinge or drawer glide if the part number matches exactly. What goes wrong: drilling new holes without a template, stripping the particleboard, or mixing overlay specs so the door gaps unevenly. For anything involving water lines, electrical rough-in, or wall repair behind the cabinets, we recommend a licensed technician. The risk isn’t just a crooked door; it’s a slow leak that rots the subfloor before you notice.

We’re an independent service provider, not affiliated with Wellborn. If you want to verify the part yourself, photograph the label and measure the overlay with the door closed. Otherwise, call us at (561) 475-3903 and we’ll bring the right hardware on the first trip. We background-check every technician, and a live person answers the phone 24/7.

FAQs