Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Toto Bathroom Remodeling: The West Palm Beach Owner’s Guide
Toto bathroom remodeling in West Palm Beach typically runs $9,000-$28,000 for a full remodel with Toto fixtures installed, and we stock the full Toto catalog including the Drake, Ultramax II, and Washlet series for same-week scheduling. Most West Palm Beach owners discover their Toto installation needs attention when the Washlet spray pressure drops, the toilet runs intermittently despite new flappers, or the SanaGloss coating has worn through after years of Florida’s mineral-heavy water. We’ve handled Toto replacements from El Cid historic homes to new builds along Flagler Drive, and the pattern is consistent: the parts last, but the installation context - water pressure, venting, and subfloor prep - determines whether they perform to spec.
Which Toto Models This Applies To
Toto’s product lines split into three tiers that matter for West Palm Beach remodels. The Drake and Drake II (CST744E, CST454CEFG) are the workhorse two-piece toilets you’ll find in most pre-2015 West Palm Beach homes; they use a standard 12-inch rough-in but the Drake II’s Tornado flush requires a minimum 1.28 GPF supply line that older Palm Beach County plumbing sometimes can’t deliver without upgrading the angle stop. The Ultramax II (MS604114CEFG) is the one-piece upgrade we spec most often in current remodels; it’s a 12-inch rough-in like the Drake, but the skirted trapway hides the bolts and demands precise floor leveling - a 1/8-inch dip at the flange and the skirt gaps visibly.
The Washlet bidet seats (C100, C200, S550e) are where compatibility gets specific. The C100 fits any elongated Toto bowl with the mounting hardware included, but the S550e’s auto-open lid requires 1.5 inches of clearance behind the tank to the wall; in West Palm Beach condos built in the 1970s and 1980s, that dimension often doesn’t exist without moving the flange forward. We carry both OEM Toto mounting hardware and the aftermarket Plumb Pak stainless bolt kits, which meet Toto’s torque spec but cost about 40 percent less. For the SanaGloss (CeFiONtect) finish, we only source Toto OEM; third-party “compatible” coatings we’ve tested in Florida’s hard water fail within 18 months.
To identify your model, lift the tank lid and check the stamped four-digit number on the porcelain wall; cross-reference with Toto’s online spec sheet, or text us a photo and we’ll match it to our stock list.
Signs Your Toto Bathroom Remodeling Is Failing

- Intermittent running or phantom flushes. The flapper chain length is the usual suspect, but on Toto’s dual-flush models the tower seal beneath the flush valve degrades faster in West Palm Beach’s chlorinated municipal water. We replace the entire flush valve assembly, not just the flapper, because the tower seal isn’t sold separately and a partial fix fails again in six months.
- Weak or angled bowl rinse. Toto’s Tornado flush uses two rim jets that clog with calcium from Florida’s aquifer water. Homeowners try wire hangers; we pull the toilet, acid-wash the rim channels, and reinstall with a new wax ring because the partial clearing always leaves debris that re-clogs.
- Washlet seat loose or power cycling. The mounting plate loosens from repeated weight shifts, but the real issue is often the GFCI outlet on a shared bathroom circuit tripping when the hair dryer starts. We map the circuit load and add a dedicated outlet where code allows.
- Skirted base leaking at floor. The Ultramax II and Carlyle II hide their bolts behind the skirt, so the leak shows as staining on the grout, not visible water. The cause is almost always an uneven flange or a wax ring compressed during a prior DIY install; we use Toto’s proprietary Uni-Fit adapter or reset the flange to true level.
- SanaGloss staining that won’t clean. The CeFiONtect glaze is glass-smooth when intact; once etched by abrasive cleaners or worn through by years of grit, the porous porcelain underneath holds stains permanently. Resurfacing is temporary; replacement is the honest recommendation.
Before
AfterReplacement Cost & What’s Included
Toto bathroom remodeling in West Palm Beach runs $9,000-$28,000 depending on scope, with fixture swaps at the lower end and full gut renovations with layout changes at the upper. A Toto toilet replacement with new flange, supply line, and seal runs $800-$1,400; adding a Washlet with dedicated GFCI outlet pushes to $1,800-$2,600. Full bathroom remodels with Toto vanity, toilet, and shower fixtures typically land at $14,000-$22,000 in the neighborhoods we work.
| Scope | Price Range | What’s Included |
|---|---|---|
| Toto toilet replacement | $800-$1,400 | Fixture, flange, wax ring, supply line, haul-away |
| Toilet + Washlet install | $1,800-$2,600 | Above plus seat, GFCI outlet, dedicated circuit if needed |
| Vanity + fixtures swap | $4,500-$8,000 | Toto vanity, faucet, mirror, lighting, paint touch |
| Full bathroom remodel | $9,000-$28,000 | Demolition, plumbing rough, tile, Toto full suite, permit, inspection |
What drives the range: subfloor condition (we’ve replaced 3/4-inch plywood rotted through in West Palm Beach’s older stucco homes), whether the drain line needs re-venting to meet current Florida Plumbing Code, and tile selection - Toto’s fixtures pair with any tile, but large-format porcelain demands a perfectly flat wall that often requires cement board replacement. Under Clause 1 of The Haven Standard, the written price covers everything in the scope; no change proceeds without a signed change order. Our 365-Day Done Right Promise covers the installation and workmanship; Toto’s manufacturer warranty covers the fixture itself.
DIY or Call Us?

There’s a clear line for Toto work. A homeowner can safely check the model number, confirm the rough-in measurement (12 inches from wall to bolt center, standard; 10 or 14 inches if the bathroom was built before 1990), and verify the shutoff valve turns freely. What goes wrong past that point: the skirted Ultramax II weighs 99 pounds dry, and the one-piece design has no flex - torque one bolt before the other is seated and the porcelain cracks. We’ve replaced three homeowner-cracked bowls in West Palm Beach in the past two years.
The Washlet’s electrical integration is the other boundary. Florida code requires GFCI protection within 3 feet of any toilet; daisy-chaining off the vanity outlet violates NEC 210.8 and voids homeowner’s insurance if there’s a fault. We pull a dedicated circuit, permit it, and inspect it. For the flange and subfloor work, the risk is structural - a leaking wax ring rots the joist bay, and by the time you smell it, the repair is $3,000, not $300. Call (561) 475-3903 and we’ll scope it with a written price before anyone picks up a wrench.
FAQs
The porcelain bowl and tank last 30-plus years; the working parts - fill valve, flapper, Washlet seat mechanism - need replacement every 7 to 12 years in Florida’s hard water and high mineral content. The SanaGloss finish, with non-abrasive cleaning, holds 15 to 20 years before visible wear. Call (561) 475-3903 for an exact quote on your model - estimates are free.
Yes, if the porcelain is sound. A fill valve swap runs $180-$260, a flush valve replacement $220-$340, both with parts and labor. But if the bowl is cracked, the trapway is scaled shut, or you’re on a third repair in five years, replacement is the better value. We stock Drake II and Ultramax II units on our truck for West Palm Beach calls. Call (561) 475-3903 for an exact quote - estimates are free.
A fixture swap is one day. A full remodel with tile, vanity, and plumbing rough-in runs 10 to 14 business days in West Palm Beach, plus permit and inspection scheduling through the City of West Palm Beach Building Division. We sequence Toto fixture delivery to arrive day-of-install, not weeks early taking up your garage. Call (561) 475-3903 to schedule - estimates are free.
We stock the Drake II, Ultramax II, and C200 Washlet in our West Palm Beach warehouse, plus flappers, fill valves, and mounting hardware for same-day repair calls. Specialty items - the S550e, Neorest integrated toilets, or custom finish plates - ship from Toto’s Morrow, Georgia distribution center in 3 to 5 business days. Call (561) 475-3903 to confirm availability for your model - estimates are free.
Rowan Construction Group West Palm Beach is an independent service provider and is not affiliated with Toto USA. We source Toto products through authorized distribution and honor all manufacturer warranties.
Measure twice, document everything, then get out of the way and let the work speak. That’s how we’ve kept projects within a few percent of the agreed price across 4,000-plus jobs since 2007. If your Toto bathroom needs attention in West Palm Beach, call (561) 475-3903 to schedule your free estimate. We’ll deliver a written price with line-item scope before anyone picks up a tool, and you’ll get a documented photo record of every visit - included, not optional.
Written by Grant Rowan, Owner, Rowan Construction Group West Palm Beach at Rowan Construction Group West Palm Beach, serving West Palm Beach and nearby areas.







Before
After
Before
After